llvm-svn: 33971

to just before the add r1, pc:

Before:
        .set PCRELV0, (LJTI1_0_0-(LPCRELL0+4))
LPCRELL0:
        mov r1, #PCRELV0
        add r1, pc

Now:
        .set PCRELV0, (LJTI1_0_0-(LPCRELL0+4))
        mov r1, #PCRELV0
LPCRELL0:
        add r1, pc

llvm-svn: 33744

there follows a sp increment for the va register save region. Instead issue
a separate pop to another register, increment sp, and then return:
        pop {r4, r5, r6, r7}
        pop {r3}
        add sp, #3 * 4
        bx r3

llvm-svn: 33739

llvm-svn: 33717

        .set PCRELV0, (LJTI1_0_0-(LPCRELL0+4))
LPCRELL0:
        add r1, pc, #PCRELV0
This is not legal since add r1, pc, #c requires the constant be a multiple of 4.
Do the following instead:
        .set PCRELV0, (LJTI1_0_0-(LPCRELL0+4))
LPCRELL0:
        mov r1, #PCRELV0
        add r1, pc

- In thumb mode, it's not possible to use .set generate a pc relative stub
  address. The stub is ARM code which is in a different section from the thumb
  code. Load the value from a constpool instead.
- Some asm printing clean up.

llvm-svn: 33664

instructions that use these address modes to instructions that use
t_addrmode_sp.

llvm-svn: 33651

llvm-svn: 33649

llvm-svn: 33568

llvm-svn: 33562

llvm-svn: 33551

llvm-svn: 33542

llvm-svn: 33484

  instructions into one (e.g. tLDRrr, tLDRri -> tLDR).
- Thumb ldrsb and ldrsh only have the [reg, reg] address format. If the
  address is not an add, materialize a 0 immediate into a register and use
  it as the offset field.

llvm-svn: 33470

llvm-svn: 33353